Bringing 1,200 watts of unused rooftop solar back to life with a Victron MPPT system, battery monitoring, and a full electrical checkup
This 2022 Thor Magnitude Super C came to us with six 200W solar panels on the roof and none of them connected. The only solar controller was the factory 10-amp PWM unit, which can handle less than 200 watts. The house batteries were running low, which kept the generator from starting and made the slide-out struggle.
We designed and installed a complete solar charging system to get full use out of the array:
- Array wiring: the six panels are wired as two strings of three (3S2P) for about 1,200 watts. We replaced the dry-rotted connectors and grouped the strings by roof zone to reduce shading from the AC units.
- Charge control: we replaced the factory PWM controller with a Victron SmartSolar MPPT 150/60, programmed for the coach’s flooded deep-cycle batteries.
- Protection: we added a dedicated PV disconnect, a battery-side fuse sized to Victron’s spec, and a chassis safety ground.
- Power distribution: we added positive and negative bus bars so the inverter, converter, alternator charging, and solar all land in one organized place.
- Monitoring: a Victron SmartShunt gives the owner real-time battery percentage, amp draw, and history on their phone over Bluetooth.
- Roof care: we resealed the cracked lap sealant around the vents and panel mounts.
Along the way we diagnosed several related issues. We traced the generator’s no-start to low house-battery voltage, and we found about a 1-amp parasitic draw that drains the batteries in storage. We also tracked a slide-out fault (Lippert code 8) to the front slide motor circuit.
The result: the batteries now charge on their own every sunny day, the owner can see exactly what’s happening from their phone, and the system is set up for an easy upgrade to lithium later.